Swamp Cooler Motor Kit 1 Horsepower 115 Volt 2 Speed For Mastercool - Includes Pulley Plug and Clamps MKM125

(4 reviews) Write a Review
SKU:
MKM125
Weight:
34.00 LBS
$259.00

Description

Replacement cooler motor kit with pulley, plug, and motor clamps for evaporative coolers, assembly required. Motor features ball bearings. Amp rating 14.4 high speed/6.8 low speed.

Replaces Adobeair P#s 940J & P112567A

View AllClose

4 Reviews

  • 5
    1 hp motor replacement

    Posted by Neal R on Jun 19th 2020

    It’s a little wider than the old motor so adjusting the mounts was annoying but it’s really quiet and no complaints after a week of use

  • 5
    1 HP 2 speed swamp cooler motor kit

    Posted by Unknown on May 23rd 2020

    fits original Mastercool swamp cooler

  • 4
    Replacement Part

    Posted by Fiercevalient on Mar 25th 2019

    Used to replace a motor that was shorting out. This new motor was slightly larger than the one it was replacing so, I needed to adjust the housing size. The electrical output on this unit also didn't line up with the AC input for my swamp cooler, but I was able to switch out the electrical cords easily. Overall, a good purchase, and I was able to get the new unit installed in about 3 hours.

  • 4
    Pully

    Posted by Bob4christ@sbcglobal.net on May 22nd 2018

    The pulley that came with it the diameter was too small to even think of fitting on that stuff the stem of the spindle so my installer pulled the old one off the old mother and put it on all Piers be working fine he said he had to rewire part of it too because it was not wear it correctly I don't know about those parts I wasn't on the roof but I knew the pulley would not fit

View AllClose