Description
Dial notched rigid replacement cooling media for AdobeAir Mobile MasterCool MMB10A. Replaces both sides of one cooler.
Dimensions and Contents
- Each assembled side: 20-1/4 inches high x 10 inches wide x 2 inches deep.
- Current Dial packaging lists two main pieces, each 19-1/4 H x 10 W x 2 D inches, plus two top pieces, each 1 H x 10 W x 2 D inches.
Important Sizing Note
AdobeAir used two pad sizes for the MMB10. This is the larger version. The store’s fit guidance says the smaller version requires trimming 1 inch from each large pad with a hacksaw. Confirm the cooler version, supplied pieces and measurements before cutting.
Pads can be removed for annual cleaning. A compatible Clean Machine purge system can assist with mineral management.
Catalog reference: 3426.
5 Reviews
-
Right size, fast shipping
New pads were super easy to final trim for sizing. Shipping was very fast. I am satisfied. Thank you!
-
They work
These pads replaced original ones, But my mmb 10a must have had the smaller pads, I did have to cut the main pads with a hacksaw, which worked out just fine.
-
Supplied
I received the pads but did not receive any instructions which I would like to look at
-
Replacement Pads
The replacement pads were an exact fit, easy to replace and operates efficiently
-
Pads
I had to throw some blue pads in temporarily while I found these and these work so much better. I would only buy an evap cooler that use this type of pad.